Krianvee is a world-class water management company providing end to end solutions for water treatment, industrial wastewater treatment, sewage treatment, desalination and Zero Liquid Discharge (ZLD) solutions at minimal costs. We have experience in designing and treating hard to treat effluent at a very nominal cost. Our expertise lies in bringing our teams together for the seamless implementation of the project. We work to implicate new technologies, reduce footprint, save energy, and deliver a state of the art water treatment plant.
Effluent is generated in many manufacturing industries like textile, pharmaceuticals and chemicals, tanneries etc. Contaminated water cannot be released without treatment as it contains toxic and non-toxic chemicals. Releasing it may cause contamination of the existing pure water and will affect the environment. As a result ETP’s are installed in most manufacturing industries.
The Effluent treatment plants (ETP) are used for the removal of high amounts of organic compounds, debris, dirt, grit, pollution, toxic, non-toxic materials and polymers etc. from industrial effluent. The ETP plants use evaporation and drying methods and other auxiliary techniques such as centrifuging, filtration , incineration for chemical processing and effluent treatment.
This chamber removes relatively large solid to avoid abrasion of mechanical equipment and clogging of hydraulic system.
The collection tank collects the effluent water from the screening chamber, stores and then pumps it to the equalization tank.
The effluents do not have similar concentration at all the time; the pH will vary time to time.
Effluents are stored for up to 8 to 12 hours in an equalization tank resulting in the homogenous mixing of effluents and helping in neutralization.
Continuous mixing also eliminates settling of solids within the equalization tank.
Reduces SS, TSS.
Lime:(800-1000 ppm) To correct the pH upto8-9
Alum: (200-300 ppm) To remove colour
Poly electrolyte : ( 0.2 ppm) to settle the suspended matters and reduce SS, TSS.
In the clarriflocculator the water is circulated continuously by a stirrer.
Flocculation provides slow mixing that leads to the formation of macro flocs, which then settles in the clarifier zone.
Overflowing water goes out to the aeration tank.
The solid particles settle down, and are collected separately; this reduces SS, TSS.
The settled solids i.e. primary sludge is pumped into sludge drying beds.
The effluent after clarification flows to an aeration tank for aerobic treatment.
This tank is equipped with air blowers or diffusers using which air is passed through the tank.
This air is required to maintain the desired dissolved oxygen (DO) level required for bacteria to grow and remove BOD and COD by breaking down the matter.
BOD and COD values of effluent are reduced up to 90%.
The overflow from aeration tank is led into the secondary clarifier where solid liquid separation takes place.
The settled solids in secondary clarifier are called biological sludge, a part of which is recycled back into the aeration tank to maintain the desired MLSS level and remaining sludge is conveyed to sludge collection tank for further treatment.
The outlet water quality is checked if it’s within the accepted.
The treated water is disposed through pipelines.
The inlet sludge consists of 60% water + 40% solids.
The effluent is passed through a centrifuge.
Due to centrifugal action, the solids and liquids are separated.
The sludge thickener reduces the water content in the effluent to 40% water + 60% solids.
The effluent is then reprocessed and the sludge is collected at the bottom.
Primary and secondary sludge is dried on the drying beds to further reduce the water content.
